Subject	Its easy
Posted by	Multi_Read (MO) on July 01, 2008 at 9:07 PM
	This message has been viewed 156 times.
In Reply To	You gotta love previous owners... posted by 94redZee(Houston) on July 01, 2008 at 08:59 PM
Message	take the top off the enclosure and then chop off the screw mounts that poke up, mark your holes with some paper or tracing paper and then make a cutout of the top piece out of MDF, 3/4" is fine. Cut out your circle, mount your speaker and the "plate" back on top of the original enclosure.... its sealed, and it sounds decent (reuse the foam seal)
Follow Ups	You gotta love previous owners... - 94redZee(Houston) 20:59:23 07/01/08 Its easy - Multi_Read (MO) 21:07:13 07/01/08 I've seen that done before on here. - 94redZee(Houston) 21:34:13 07/01/08 I wouldn't bother trying to make a hole for the port. - robo (sebring1970) 21:53:43 07/01/08 Or just buy a 90 model rear enclosure used that already has - twinturbopoweredz 23:06:00 07/01/08 2nd, I just did this in mine. Except for the drivers side - Musashi Sword 10:34:05 07/02/08 Either that or get some putty... - CameronSF 21:56:05 07/01/08 mighty putty!!! (n/m) - 96300NAZ 22:25:15 07/01/08 While were on the subject of previous owners - RedTTZ91(OK) 22:18:55 07/01/08 Sadly, I know how you feel... - 94redZee(Houston) 23:14:53 07/01/08 Buy pre-made adapters - see link - rjp288524 07:16:24 07/02/08 Those are junk. (n/m) - Bernie (NoVA) 22:33:38 07/02/08 If I had a nickel for every dumb thing my PO did... (n/m) - Jinjiro 08:22:40 07/02/08 I bet my dumb PO tops your dumb PO (n/m) - ZXRider(SoCal) 10:24:08 07/02/08 Its really not necessary to have it in a sealed enclosure - MPV TT 12:30:42 07/02/08
Post a Followup	You cannot reply to this message because you are not logged in.