| Message |
It's grinding the piston rings and getting them to the right spacing that was tricky. First there is some math to do and figure out the spacing you need. We used a dremel with a grinding wheel. I held it and he closed the ring onto the wheel grinding off a little at a time. Put it in the cylinder and push it in with an upside down piston. Then use a feeler guage to see what your gap is.
 "Well I have an ex-wife, a girlfriend with 2 kids, 4 kids of my own, a boss and, a mother. I don't have any more room for making people happy."
"She's always wet and hot and purrs when I slide inside of her. She screams when I put my foot down and isn't too hard to control. She is usually straight but she slides her rear out when I ask her too. Always gives me a boost. Stays with me and leaves the other guys behind. She is even more fun when her top is off...so free. Sometimes a friend will join in, male or female, and we both enjoy her. Plus she is a non smoker...what more can you ask for?"
|
 |
