Subject	I molded it into the center console,
Posted by	zboost(NoVA) on May 29, 2008 at 4:29 PM
	This message has been viewed 126 times.
In Reply To	DEFI Control Unit mounting question: posted by GPA on May 29, 2008 at 04:23 PM
Message	where the little tab thing is right above the din pockets and below the vents, I am going to put it in the glove bo now though along with my boost controller. BEST 1/4mile 11.92 @ 117mph. PUMP gas, true 11 sec. street car :) (VGTT set-up) stock turbos/injectors "yo yo. writing this one in jail - tight300zx" I hope you got soap on a rope?? (n/m) - Spongerider :) 19:14:08 04/01/04 we'll know if the screen name changes ;) (n/m) - SactoTodd 19:32:36 04/01/04 "I did plug the holes, But I did it by taping over them a lot, I didnt think that maybe HOT air is comming through there, And it melted the tape, damnit im an ass." - - DC 21:11:01 02/18/04 (the "holes" were located on the exhaust)
Follow Ups	DEFI Control Unit mounting question: - GPA 16:23:11 05/29/08 I molded it into the center console, - zboost(NoVA) 16:29:48 05/29/08 I'm thinking about the glove box. - GPA 16:37:09 05/29/08 glove compartment (n/m) - Guapo 16:37:07 05/29/08 agreed. (n/m) - Bernie (NoVA) 16:45:02 05/29/08 3rd. (n/m) - whitepearlz 19:00:38 05/29/08 On top of steering column, DIN, glovebox - SuparexTT 20:21:09 05/29/08 In the stock clock space (dremeled out) - Greg (Dallas) 21:48:06 05/29/08
Post a Followup	You cannot reply to this message because you are not logged in.