Subject	Mine is between 21 - 23 in. HG at idle. I had the same
Posted by	MAD_96TT(MO) on May 06, 2008 at 1:40 PM
	This message has been viewed 96 times.
In Reply To	Boost Guage posted by 300zx_tt_z32 on May 06, 2008 at 01:12 AM
Message	problem as you. I was only reading about 12 - 15 in. HG then I pulled it out and noticed that the plastic line coming off the gauge would crease as soon as I re-installed the gauge. So I wrapped the plastic line in electrical tape, fairly thick, from the gauge to about two inches down the tubing. That helped allow it bend without creasing while putting it in the a-pillar pod. Z's Kick Ass!! Boost - It's An Addiction! "Like a retired James Bond, the Z exudes an air of understated class." ------> Sports Compact Car Magazine
Follow Ups	Boost Guage - 300zx_tt_z32 01:12:10 05/06/08 Did you use teflon tape on the adapter when you installed it - BlackTT91 01:45:13 05/06/08 There definately is a leak some where. I have pretty much - DWolak3 09:41:31 05/06/08 mine is at -20 @ idle (~750-800rpm) (n/m) - RedSER13 09:44:52 05/06/08 21-23 In. Hg - SkiFly01 13:14:44 05/06/08 A couple of points.... - BrianK 11:03:54 05/06/08 what is a negative psi? (n/m) - Guapo 11:07:52 05/06/08 tha Suck (n/m) - Tennyson (ATL) 11:47:43 05/06/08 That's how you measure boost when you drive backwards. (n/m) - Eric(NJ) 12:25:22 05/06/08 LOL! (n/m) - Viper498 ( MO ) 15:17:30 05/06/08 Negative PSI is fine - lazer(AK) 16:22:47 05/06/08 Mine is between 21 - 23 in. HG at idle. I had the same - MAD_96TT(MO) 13:40:05 05/06/08
Post a Followup	You cannot reply to this message because you are not logged in.