Subject	I'm talking about the suspension link bushings (lower
Posted by	Inzane on April 30, 2008 at 4:08 PM
	This message has been viewed 110 times.
In Reply To	Lube 'em posted by BigTDogg (MA) on April 30, 2008 at 03:23 PM
Message	control arms, knuckle, lower shock mount, etc.), not what comes in the common "master kit". I wouldn't expect polyurethane *subframe* bushings to make much if any noise. They don't move like the pivot points do. And as far as the tension rods go, I've always had spherical bearing rod ends (adj. tension rods), so I have no experience with polyurethane in that spot. But R&R'ing those would be a hell of a lot easier than the particular bushings I'm talking about. Inzane (formerly Z-Jay)
Follow Ups	Need Advice from Drag Racers - jcieslik 19:57:12 04/29/08 dont see why - genic 20:00:22 04/29/08 no (n/m) - ali300zx 20:30:46 04/29/08 That is what I needed to know. Thanks. (n/m) - jcieslik 22:25:36 04/29/08 Consider the Nismo bushings instead of ES for the rear - Inzane 23:36:03 04/29/08 Why? Because they are too stiff? (n/m) - jcieslik 08:39:49 04/30/08 Squeak.... squeak... squeak... > - Inzane 10:18:31 04/30/08 Did you have the red or black bushings - jcieslik 12:35:17 04/30/08 Mine are red. :-/ (n/m) - Inzane 14:26:03 04/30/08 Lube 'em - BigTDogg (MA) 15:23:00 04/30/08 Re: Lube 'em - Bellaco 15:27:49 04/30/08 SOL unless you drop the subframe and or tension rods - BigTDogg (MA) 15:45:12 04/30/08 I'm talking about the suspension link bushings (lower - Inzane 16:08:17 04/30/08 you can't use the spacers with the es bushings - spyhunterTT + 93Vert(nj) 18:42:26 04/30/08
Post a Followup	You cannot reply to this message because you are not logged in.