Subject	Dremel has a nice polishing kit too - little bullet shaped
Posted by	jzack on March 02, 2007 at 6:12 PM
	This message has been viewed 40 times.
In Reply To	Polishing Question posted by Neogenesis on March 02, 2007 at 05:48 PM
Message	felt bulbs, etc.
Follow Ups	Polishing Question - Neogenesis 17:48:58 03/02/07 *drool (n/m) - nemo1080 17:57:52 03/02/07 Try the eastwood catalog. Also try a buff with compound to - whatsthegoodword 18:03:07 03/02/07 What grit of compound should I start out with? - Neogenesis 18:14:33 03/02/07 If anybody knows... - Neogenesis 18:22:40 03/02/07 Nevermind, found the answer. - Neogenesis 18:46:36 03/02/07 In general, I wish I had my polished parts chromed. Tried - whatsthegoodword 18:59:45 03/02/07 Big 2nd, I spent a lot of time polishing and used zoopseal - CatnipZ 09:48:49 03/03/07 Dremel has a nice polishing kit too - little bullet shaped - jzack 18:12:47 03/02/07 (edit) I think this is what you are looking for>> - Spongerider :) 18:13:55 03/02/07 I will definitely be needing that as well as the compound. - Neogenesis 18:15:48 03/02/07 Also if you read this link "How to Buff and Polish" - Spongerider :) 18:22:44 03/02/07 (Total Hits: a lot) - Neogenesis 18:26:25 03/02/07 Thank you! (n/m) - Spongerider :) 18:28:49 03/02/07 I polished my CAS and just knocked the roughcast off with 80 - ShakaShaun(Denver) 18:22:04 03/02/07 Would you direct me to the compound you used as a reference? - Neogenesis 18:24:14 03/02/07 I picked mine up at ace hardware. they came in a 3 pack - ShakaShaun(Denver) 18:39:59 03/02/07 How much did that last you? I plan on polishing everything - Neogenesis 18:48:12 03/02/07 I used maybe 1/3 of each compound just for the CAS - ShakaShaun(Denver) 19:12:20 03/02/07 Polishing is messy. Wear a dust mask. (n/m) - AzHeat 18:53:24 03/02/07 Those are actually my water pipes... - Grateful Zed 19:01:56 03/02/07 UGHHH.... Brings back some painful memories for me... - Jodecy 20:25:00 03/02/07
Post a Followup	You cannot reply to this message because you are not logged in.