Subject	i would go past 80 grit...
Posted by	nemo1080 on February 26, 2007 at 12:51 AM
	This message has been viewed 64 times.
In Reply To	Ceramic coated engine parts. I'm polishing a spare plenum posted by 240Z FeO2 on February 26, 2007 at 12:36 AM
Message	as far as the coating, i have no helpful advice... but 80 grit just seems a little rough It's not turbo lag, It's foreplay!
Follow Ups	Ceramic coated engine parts. I'm polishing a spare plenum - 240Z FeO2 00:36:20 02/26/07 i would go past 80 grit... - nemo1080 00:51:22 02/26/07 Heres my plenum ceramic coated silver after being polished - Crim 07:24:55 02/26/07 I don't know about durability... - Dallas DamonZ 08:01:52 02/26/07 Ummm... you'll need to go higher than an 80 grit... - BigTDogg (MA) 08:14:52 02/26/07 I've read numerous posts here about polishing and Caswell - 240Z FeO2 11:33:59 02/26/07 Not the best shot, but here's my water pipes after - BigTDogg (MA) 11:57:53 02/26/07 Lookin' good. As soon as I get through with this plenum - 240Z FeO2 12:03:56 02/26/07
Post a Followup	You cannot reply to this message because you are not logged in.