Subject	Possible a piece could vibrate/chip off of the bolt head...
Posted by	BOOZTD 3 on December 11, 2006 at 1:24 PM
	This message has been viewed 72 times.
In Reply To	they couldnt back out (since they butt up against the posted by BFastRBLast (Ca) on December 11, 2006 at 01:11 PM
Message	Piece comes in contact with the turbine wheel, maybe
Follow Ups	PSA: Megan Racing Downpipes.... - BOOZTD 3 10:28:30 12/11/06 once you tightened the bolts, were they good to go? - ZEngineer 10:32:53 12/11/06 It was a simple fix, yes.... - BOOZTD 3 10:39:02 12/11/06 mine are great. (n/m) - nemo1080 10:57:37 12/11/06 2nd (n/m) - bjamin 12:57:20 12/11/06 3rded (n/m) - Crim 14:12:31 12/11/06 I noticed that also on my old Z. BTW - Slow3z 11:00:14 12/11/06 It was me.... - BOOZTD 3 12:07:16 12/11/06 Thats weird, my wastegate separators were off the dp's - TTFairladyZ 11:57:56 12/11/06 they couldnt back out (since they butt up against the - BFastRBLast (Ca) 13:11:20 12/11/06 Possible a piece could vibrate/chip off of the bolt head... - BOOZTD 3 13:24:46 12/11/06 That's a stretch ;) (n/m) - BFastRBLast (Ca) 13:41:15 12/11/06 Thanks again Man.. Andy is the man! - 1991300zxtt(IN) 13:44:02 12/11/06 Buth sets I installed were the same way. - ShakaShaun(Denver) 13:58:07 12/11/06 mine were upside down too - turbomaniac 15:34:39 12/11/06 Re: PSA: Megan Racing Downpipes.... (n/m) - boost baby 17:08:48 12/11/06 Re: Re: PSA: Megan Racing Downpipes.... - boost baby 17:16:35 12/11/06 Mine where not tight but it was obvious that they left them - spddracer 17:30:13 12/11/06
Post a Followup	You cannot reply to this message because you are not logged in.