TwinTurbo.NET: Nissan 300ZX forum - Re: *Sigh*, here we go again Z1...
People Seeking Info
 
   


     
Subject Re: *Sigh*, here we go again Z1...
     
Posted by Brady713 on September 12, 2006 at 9:05 PM
  This message has been viewed 99 times.
     
In Reply To *Sigh*, here we go again Z1... posted by Black_93_300ZX on September 12, 2006 at 06:53 PM
     
Message Sorry to hear you had a difficult time with Z1. I have been doing business with them for a couple of years know. Stage 1 turbo swap, Z1 down pipes, Z1 one piece drive shaft, Z1 ECU, new engine harness installed, 555cc nismo installed, ECU custom remapped on dyno. There were a couple of mistakes, but not by Russell. Russell did however make it up. Had a pinched heater core hose and was picking my car up on a Sat. afternoon. He and a mech. replaced both free and checked the car over completely. They stayed until about 10:00 that night to make sure everything was perfect. Went back recently for the injector upgrade and dyno run. They pulled on the dyno until Russell was well satisfied with the eprom. He custom burned the eprom according to the dyno numbers. He knows what he is doing. Everyone at Z1 has always gone out of their way to make sure I'm completely satisfied and my z is in top shape. Not sure what happened to your order, but mine have always been perfect...

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.