Subject	LOL! Your dads gonna pull out a red pile of you with a
Posted by	nemo1080 on May 03, 2006 at 11:10 AM
	This message has been viewed 33 times.
In Reply To	What is the weight of a manual transmission posted by 4NIK8 on May 02, 2006 at 09:16 PM
Message	tranny in it somewhere. Just use a jack. I used a jack and 4 ppl. A little excessive but i didnt feel like dropping 100lbs of dead weight on my head, or buyin a new tranny because I dropped it and cracked the houseing. I put 2 guys on each side of bell housing and 2 on tail shaft, we rocked it off and set on jack, lowered jack and wheeled it away. It worked pretty well. It's not turbo lag, It's foreplay!
Follow Ups	What is the weight of a manual transmission - 4NIK8 21:16:11 05/02/06 about 90lbs. - zboost(tx) 21:18:51 05/02/06 Just to put in perspective... a bag of cement is like 70lbs. - zboost(tx) 22:27:12 05/02/06 Make sure you drain it of fluid - Moxie 21:22:22 05/02/06 Bruce, did you eat paint chips as a kid? - brahmabull (NoVA) 21:22:50 05/02/06 You aren't Spee, don't try it. (n/m) - WickedZX (NoVA) 21:25:13 05/02/06 I hope you don't do an engine pull the same way (n/m) - bama Z 21:27:23 05/02/06 200 pounds? Really? Sorry for the sarcasm. It be a - Riddick 21:36:30 05/02/06 You can get a floor jack for about $100 - dmv300z 21:36:50 05/02/06 How on earth did your friend manage that? - The Sixth 21:48:52 05/02/06 doing it wrong.. - AntiHero 21:53:05 05/02/06 I've done that with a maxima m/t and a 91 talon tranny. - ENVYMYZ 21:54:14 05/02/06 That's how I do miata trannies and most fwds - dogpile (used to be dogpile) 08:39:43 05/03/06 I would assume the Z's trans would be heavier. - ENVYMYZ 08:51:07 05/03/06 I use a trans jack for zs. miata trans = 80lbs dry - dogpile (used to be dogpile) 09:48:24 05/03/06 Re: What is the weight of a manual transmission - CDBZ 22:01:40 05/02/06 Good way to mess up & end up in the hospital. (n/m) - YugoBernie (NoVA) 22:25:16 05/02/06 Only cost my dad one tooth. (n/m) - Kenny 22:48:23 05/02/06 I have a friend who did that with a 84 Ford Diesel C4 - TBlakeZ (NorCal) 22:34:44 05/02/06 When I pulled my motor once, I just put my body undernieth - suprakillinz 22:44:17 05/02/06 lol - Spee 23:07:27 05/02/06 Not to mention the vertical CLEARANCE required to clear - Z-Jay (Edmonton, AB) 00:49:33 05/03/06 Well, the guy that installed my clutch dropped the - olyar15 23:13:57 05/02/06 My neighbor has a tranny jack and didn't use it when he - Only1Z 23:40:58 05/02/06 Do your self a favor... - DVDBURN (MD) 23:46:37 05/02/06 I weighed one back in the day - it was dead-on 120# - Ash's Z 00:06:13 05/03/06 for a z32 5 spd? you sure? (n/m) - Waco300zx 00:16:28 05/03/06 Oh, and you got my payment right? (n/m) - Waco300zx 00:33:46 05/03/06 get a jack, although I've manhandled it off my chest before. - Waco300zx 00:15:15 05/03/06 That's how i do it - i wouldn't recommend it - Joe(NoVA) 09:15:06 05/03/06 man, that's ghetto... rent a jack if you can't afford one - RedSER13 09:29:10 05/03/06 lol, 2nd. (n/m) - stockplayerz (NYC) 09:35:42 05/03/06 LMAO - 93silverTT 10:02:16 05/03/06 LOL! Your dads gonna pull out a red pile of you with a - nemo1080 11:10:48 05/03/06 According to UPS: 140 lbs. But that included the shipping - Dave N 12:32:41 05/03/06
Post a Followup	You cannot reply to this message because you are not logged in.