Subject	Make sure you drain it of fluid
Posted by	Moxie on May 02, 2006 at 9:22 PM
	This message has been viewed 39 times.
In Reply To	What is the weight of a manual transmission posted by 4NIK8 on May 02, 2006 at 09:16 PM
Message	first. Then, take off the driveshaft, disconect all the sifter linkage, take out all the bolts you can get to around the tranny, then put a jack on the end of tranny if you don't have a tranny jack, and unbolt the tranny mount, then lower the tranny a bit to get at the top bolts on the tranny where it connects to the engine. Once you have them all off, just slide it out, and keep lowering the jack... you should be fine. I pull it by myself and there is no way I can bench 200lbs. -------------------------------------------------------------------------------- Member # 42254's 1991 Twin Turbo Sig Quotes: your brillant (n/m) - Zski (Generation Z) 14:36:48 06/17/04 Fat kids will eat anything. (n/m) - SooperZ95 22:13:47 07/05/04 Get divorced. (n/m) - Kenny 22:10:09 07/07/04 BTW, spelling has nothing to do with being stupid, stupid. - AzHeat 22:08:35 11/21/04 First of all, we already know you're a little pussy bitch from San Francisco - Marshall 21:36:41 06/08/05 Are you in the know?
Follow Ups	What is the weight of a manual transmission - 4NIK8 21:16:11 05/02/06 about 90lbs. - zboost(tx) 21:18:51 05/02/06 Just to put in perspective... a bag of cement is like 70lbs. - zboost(tx) 22:27:12 05/02/06 Make sure you drain it of fluid - Moxie 21:22:22 05/02/06 Bruce, did you eat paint chips as a kid? - brahmabull (NoVA) 21:22:50 05/02/06 You aren't Spee, don't try it. (n/m) - WickedZX (NoVA) 21:25:13 05/02/06 I hope you don't do an engine pull the same way (n/m) - bama Z 21:27:23 05/02/06 200 pounds? Really? Sorry for the sarcasm. It be a - Riddick 21:36:30 05/02/06 You can get a floor jack for about $100 - dmv300z 21:36:50 05/02/06 How on earth did your friend manage that? - The Sixth 21:48:52 05/02/06 doing it wrong.. - AntiHero 21:53:05 05/02/06 I've done that with a maxima m/t and a 91 talon tranny. - ENVYMYZ 21:54:14 05/02/06 That's how I do miata trannies and most fwds - dogpile (used to be dogpile) 08:39:43 05/03/06 I would assume the Z's trans would be heavier. - ENVYMYZ 08:51:07 05/03/06 I use a trans jack for zs. miata trans = 80lbs dry - dogpile (used to be dogpile) 09:48:24 05/03/06 Re: What is the weight of a manual transmission - CDBZ 22:01:40 05/02/06 Good way to mess up & end up in the hospital. (n/m) - YugoBernie (NoVA) 22:25:16 05/02/06 Only cost my dad one tooth. (n/m) - Kenny 22:48:23 05/02/06 I have a friend who did that with a 84 Ford Diesel C4 - TBlakeZ (NorCal) 22:34:44 05/02/06 When I pulled my motor once, I just put my body undernieth - suprakillinz 22:44:17 05/02/06 lol - Spee 23:07:27 05/02/06 Not to mention the vertical CLEARANCE required to clear - Z-Jay (Edmonton, AB) 00:49:33 05/03/06 Well, the guy that installed my clutch dropped the - olyar15 23:13:57 05/02/06 My neighbor has a tranny jack and didn't use it when he - Only1Z 23:40:58 05/02/06 Do your self a favor... - DVDBURN (MD) 23:46:37 05/02/06 I weighed one back in the day - it was dead-on 120# - Ash's Z 00:06:13 05/03/06 for a z32 5 spd? you sure? (n/m) - Waco300zx 00:16:28 05/03/06 Oh, and you got my payment right? (n/m) - Waco300zx 00:33:46 05/03/06 get a jack, although I've manhandled it off my chest before. - Waco300zx 00:15:15 05/03/06 That's how i do it - i wouldn't recommend it - Joe(NoVA) 09:15:06 05/03/06 man, that's ghetto... rent a jack if you can't afford one - RedSER13 09:29:10 05/03/06 lol, 2nd. (n/m) - stockplayerz (NYC) 09:35:42 05/03/06 LMAO - 93silverTT 10:02:16 05/03/06 LOL! Your dads gonna pull out a red pile of you with a - nemo1080 11:10:48 05/03/06 According to UPS: 140 lbs. But that included the shipping - Dave N 12:32:41 05/03/06
Post a Followup	You cannot reply to this message because you are not logged in.