Subject	SELLING: 300zx 2JZGTE VVTi Swap Harnesses - Now Available
Posted by	wiring specialties on January 20, 2017 at 10:05 AM
	This message has been viewed 921 times.
	Screen Name: wiring specialties Real Name: Yury Lyalko Phone: 508-274-0464 Location: Brookefield, CT 06804 USA E-mail: sales@wiringspecialties.com Research wiring specialties's post history
Message	Available in Plug and Play for the 300zx and Fairlady Z32. Many aftermarket accessories supported. The Wiring Specialties 2JZGTE VVTi wiring harness is ideal for those looking for the best in aesthetics, weight savings and reliability. Our harnesses are designed from the ground-up to exceed OEM specifications for wire quality, power/ground routing. With our optimized and 'tucked' approach the end result will be a clean and worry free installation with a guaranteed start up?.? Completely replace your old OEM harness and never worry about electrical gremlins again. http://www.wiringspecialties.com/1j2jharness.html PRO-SERIES HARNESS SPECS: Plug and Play – simple and efficient NO CORE HARNESS or additional wiring required OEM wire colors used, where applicable All sensor signal connection use EM shielded wires Fireproof fiberglass sleeving used in high-temp sections near the manifold & turbo (-40°C/-40°F to +450°C/+845°F operating temperature) Point-to-Point continuity tested on every wire Constructed using exact OEM connectors and seals Made with high temp TXL wire with adhesive shrink tubing (-40°C/-40°F to +125°C/+257°F operating temperature) Wrapped in lightweight nylon loom (-94°C/-137°F to +125°C/+257°F operating temperature) Includes a charge harness and improved grounds Fully tested after production for an easy plug-and-play installation PRO-SERIES HARNESS INCLUDES: Main Engine and Transmission one-piece tucked harness 3x Coilpack connections 2x Knock sensor connectors MAP connector IAT connector TPS connector Boost solenoid wiring (with AEM/Haltech or aftermarket computers) VVT-I connector 10-pin igniter chip connector (relocated to inside the car) 2x CAM sensor connector Crank sensor connector Throttle motor connector OEM Oxygen sensor connectors (wideband wiring is not part of the EFI harness, except AEM Infinity 6/8) 2 x Ground ring terminal ECT sensor connector and cluster coolant temp switch connector Reverse lights sensor connector Speed sensor connector Alternator connector Starter signal connector OEM oil pressure 1-pin connector Speed and Tach signal converter connector ECU Diagnostics mode connector ** No traction Control wiring supplied Printable install instructions with pictures Turn Key ENGINE START Guarantee
Follow Ups	300zx 2JZGTE VVTi Swap Harnesses - Now Available - wiring specialties 10:05:00 01/20/17