| Parting out a few engine builds/z32's. Some prices are obo, the more you buy the more I can knock off. Buyer responsible for Paypal fees and Shipping costs. *All parts are brand new unless otherwise stated. *Txt or email for questions/pics
-24 OEM lifters purchased from Nissan
$680
-Wiseco coated piston 88mm, Eagle Rods w/eagle pins, Wiseco ring kit, tapered ring compressor
$980
*(I do have a machined block for this setup if interested) -Coated Clevite Main and Rod bearings
$100 -ACL Main and Rode bearings
$110 -Z1 Cometic 88mm MLS headgasket .019" thicker then oem
$200 -OEM TT oil pump
$150 -OEM TT Water pump
$70 -OEM TT t-belt tensioner
$130 -GMB Idler tensioner pulleys (upper+lower)
$70 -BDE Half moons
-Gates oem timing belt
-OEM coolant bypass tubes + CZP silicone hoses
-OEM Rear main seal
-Ramey Z idler studs
$110 -OEM Knock sensor+ OEM Harness
$100 -TT mint Shaved/custom Fan shroud black 6+hrs of work
$180 -Nismo Thermostat
$80 -Used OEM TT oil pan(ok condition paint wise, no dents/cracks) + Brand new oem oil pickup tube
$150 -Used ATI super street damper pulley +new oem drivebelts
$450
-Used Apexi Safc Neo (lets you tune ecu, and run dual intake without needing selin setup)
$300
-Used Samco Silicone Radiator hose set in black
$100 -Used Nismo oil cooler
$170 -SZ BB Stainless steel oil feed lines
$100 -BDE Top feed fuel rails(no injectors) w/upgraded lower plenum, upper plenum(PC'd red) and balance tube
$650 -Ash spec twin pump fuel controller
$190 -(Used for 4k miles) Southbend Billet flywheel + Stage 6 clutch/pressure plate
$700 -Sparco Quick release disconnect
$250 Im sure there are more parts Im forgetting, don't be afraid to ask. email/txt preferred (206) 200-9912
|
