| Below are flat rate prices, anything not listed below is 75$ per hour of labor including diagnostics. Word of mouth explains why you would pay these premiums. All prices below are for labor, parts NOT included unless specified. Services, pre-purchase inspections
-----------------------------------------------------------------------
40$ EFI Data scan
50$ boost leak check
60$ compression check
100$ compression & cylinder leak down check
60$ injector ohming 80$ pre-purchase check out inspection (test drive, efi data scan, body, suspension, engine, etc) addition for services listed above
Electronics
------------------------------------------------------------------------
40$ EFI Data scan
50$ setting ignition timing, idle control, synchronize throttle bodies, code & sensor check (the right way); total for all
60$ Turbo Timer
+ 20$ e brake function
+ 20$ RPM/MPH ECU tap in 75$ PTU sub-harness delete
+ 20$ PTU relocation 60$ injector connector replacement (for all six)
80$ coil pack connector replacement
120$ injector and coil pack connector replacement 50$-200$ gauge installations
250$ triple electronic gauge in din pocket
100$ Apexi SAFC, SAFC2, SAFC Neo
100$-250$ wideband installations
200$ AVC-R apexi EBC (w/scramble boost switch) and similar EBC's
170$ Techtom IIC-460 3 step launch controller 50$ socketed ECU chip install
400$ Nistune installed, base tuning Starting at 40$ Stereo, DVD, NAV, speaker & amp installations All electrical work is done professionally. It is soldered and heat shrunk with proper preliminary precautions taken to insure no damage during install and long lasting trouble free performance.
Engine
------------------------------------------------------------------------
100$ radiator replacement or upgrade
130$ light weight crank pulley
150$ full pulley set
400$/450$(NA/TT) 60k maintenance, timing belt,T-stat, water pump, and front seals 450$ knock sensor replacement
40$-70$ individual injector replacement (dremel)
350$ injector replacement (remove and replace upper plenum) 325$ valve cover seal replacement
+ 20$ direct injector replacement
+ 70$ PCV reroute upgrade (parts included) 350$ oil pan gasket or oil pan replacement
300$ NA headers or exhaust manifold gasket replacement
700$ camshaft and/or lifter/tappet replacement 200$ intercooler replacement
450$ 2.5 SMIC piping & intercoolers
650$ 2.5 Intake, SMIC piping & intercoolers 1200$ turbo replacement only
+ 20$ manifold replacement
+ 40$ oil pan reseal
+ 90$ 60K service
+ 30$ clutch/flywheel rear main
+ 50$ injectors
+ 30$ valve cover seals
+ 40$ pcv reroute modification 350$ downpipe installation (OEM removal)
150$ downpipe installation (none OEM removal)
100$ Test Pipe isntallation
80$ Cat-Back installation 700$ NA full engine replacement
900$ NA long block replacement
1100$ NA short block replacement 1100$ Twinturbo full engine replacement
1900$ Twinturbo long block replacement.
2400$ Twinturbo short block replacement 2500$ Twinturbo conversion
3200$ Twinturbo conversion w/AT to MT conversion Transmission
---------------------------------------------------------------
50$ Shifter bushings (bushings included)
55$ clutch slave
75$ clutch master 120$ 1pc Driveshaft installation 180$ differential Bushings 400$ clutch, flywheel, and rear main seal replacement
+ 50$ knock sensor replacement
+ 30 downpipe and testpipes 450$ automatic transmission replacement or tq converter, flex plate, rear main seal
+ 50$ knock sensor replacement
+ 30$ downpipe and testpipes
Suspension / Brakes w/ Alignment = (A), w/bleeding = (B)
----------------------------------------------------------------------------------
75$ brake master cylinder
80$ front and rear brake pads + rotor replacement (B)
130$ rotor upgrade kit (w/bleeding)
150$ big Brake Kit installation (w/bleeding)
250$ shocks and/or springs replacement (A)
+100 Front and Rear upper control arms 290$ coilover installation, (w/set ride height,A)
+150 corner weighted and balanced on scales 100$ tension rod bushing
140$ adjustable tension rods (A)
180$ front upper adjustable control arms (A)
180$ rear upper adjustable control arms (A)
170$ front inner and/or outer tie rods
170$ rear inner HICAS tie rods (A)
200$ rear outer HICAS ball joints (A)
250$ steering rack (A)
200$ HICAS delete bar (stillen/powertrix style) (A)
SPL style 125$ fuel tank replacement 2+2
440$ fuel tank replacement 2+0 (A) 50$ Subframe collar kit (spl, greg dupree, SZ, F1)
390$ rear subframe replacement (A,B)
585$ Rear Subframe over haul, all bushings for all components (A,B) Air Conditioning and Heating (r134 recharge included, r12 available)
---------------------------------------------------
90$ vacuum and recharger
750$ compressor and drier (r134)
250$ evaporator and or expansion valve
500$ heater core
250$ door actuator servos/motors
500$ hear core actuator servo
Z33 services
---------------------------------------------------------------
300$ clutch and or flywheel (also g35) 350$ headers 100$ light weight Crank pulley 100$ radiator 150$ lowering springs + 50$ for struts 80$ front and rear brake pads + rotor replacement Call or email me for any and all inquiries for Z32's, Z33/G35/G37, Z34, S13, S14, Q45, J30, or non Nissan/Infiniti repairs.
Import, domestic, euro, gas and diesel.
Dane Miller
Houston Z
16038 sweet fern st
Houston TX 77070
713-204-8136
danemillertx@gmail.com
La-Z-Link Formerly known as Spooly D
|
Houston Z, Z32 Diagnostics, Service, Performance, Repair - 
