TwinTurbo.NET: Nissan 300ZX forum - Z Services in Houston Tx
People Seeking Info
 
   


     
Subject SELLING: Z Services in Houston Tx
     
Posted by Dane (Houston) on January 01, 2013 at 12:28 AM
  This message has been viewed 561 times.
     
 
Screen Name:Dane (Houston)
Real Name:Dane Miller
Phone:713 204 8136
Location:Houston, TX 77070 USA
E-mail:HoustonZAuto@gmail.com
Research Dane (Houston)'s post history
 
     
Message Below are flat rate prices, anything not listed below is 75$ per hour of labor including diagnostics. Word of mouth explains why you would pay these premiums.

All prices below are for labor, parts NOT included unless specified.

Services, pre-purchase inspections
-----------------------------------------------------------------------
40$ EFI Data scan
50$ boost leak check
60$ compression check
100$ compression & cylinder leak down check
60$ injector ohming

80$ pre-purchase check out inspection (test drive, efi data scan, body, suspension, engine, etc) addition for services listed above


Electronics
------------------------------------------------------------------------
40$ EFI Data scan
50$ setting ignition timing, idle control, synchronize throttle bodies, code & sensor check (the right way); total for all

60$ Turbo Timer
+ 20$ e brake function
+ 20$ RPM/MPH ECU tap in

75$ PTU sub-harness delete
+ 20$ PTU relocation

60$ injector connector replacement (for all six)
80$ coil pack connector replacement
120$ injector and coil pack connector replacement

50$-200$ gauge installations
100$ Apexi SAFC, SAFC2, SAFC Neo
100$-250$ wideband installations
200$ AVC-R apexi EBC (w/scramble boost switch) and similar EBC's
150$ Techtom IIC-460 3 step launch controller

50$ socketed ECU chip install
400$ Nistune installed, base tuning

Starting at 40$ Stereo, DVD, NAV, speaker & amp installations

All electrical work is done professionally. It is soldered and heat shrunk with proper preliminary precautions taken to insure no damage during install and long lasting trouble free performance.


Engine
------------------------------------------------------------------------
100$ radiator replacement or upgrade
130$ light weight crank pulley

400$/450$(NA/TT) 60k maintenance, timing belt,T-stat, water pump, and front seals

450$ knock sensor replacement
40$-70$ individual injector replacement (dremel)
350$ injector replacement (remove and replace upper plenum)

325$ valve cover seal replacement
+ 20$ direct injector replacement
+ 70$ PCV reroute upgrade (parts included)

350$ oil pan gasket or oil pan replacement
300$ NA headers or exhaust manifold gasket replacement
700$ camshaft and/or lifter/tappet replacement

200$ intercooler replacement
450$ 2.5 SMIC piping & intercoolers
650$ 2.5 Intake, SMIC piping & intercoolers

1100$ turbo replacement only
+ 20$ manifold replacement
+ 40$ oil pan reseal
+ 90$ 60K service
+ 30$ clutch/flywheel rear main
+ 50$ injectors
+ 30$ valve cover seals
+ 40$ pcv reroute modification

700$ NA full engine replacement
900$ NA long block replacement
1100$ NA short block replacement

1000$ Twinturbo full engine replacement
1800$ Twinturbo long block replacement.
2200$ Twinturbo short block replacement

2500$ Twinturbo conversion
3000$ Twinturbo conversion w/AT to MT conversion

Transmission
---------------------------------------------------------------
400$ clutch, flywheel, and rear main seal replacement
+ 50$ knock sensor replacement

450$ automatic transmission replacement or tq converter, flex plate, rear main seal
+ 50$ knock sensor replacement


Suspension / Brakes
---------------------------------------------------------------
80$ front and rear brake pads + rotor replacement (w/bleeding)
130$ rotor upgrade kit (w/bleeding)
150$ big Brake Kit installation (w/bleeding)

250$ shocks and/or springs replacement (w/alignment)

400$ coilover installation, (w/set ride height, corner weight balance, and alignment)

100$ tension rod bushing

140$ adjustable tension rods (w/alignment)

250$ steering rack (w/alignment)


Z33 services
---------------------------------------------------------------

300$ clutch and or flywheel  (also g35)

350$ headers

100$ light weight Crank pulley

100$ radiator

150$ lowering springs + 50$ for struts

80$ front and rear brake pads + rotor replacement

Call or email me for any and all inquiries for Z32's, Z33/G35/G37, S13, S14, Q45, J30, or non Nissan/Infiniti repairs.
Import, domestic, euro, gas and diesel.


713-204-8136
danemillertx@gmail.com


Dane Miller
Houston Z
16038 sweet fern st
Houston TX 77070

Houston Z's Facebook

Formerly known as Spooly D



Uploaded from the Photobucket Android App

     
Follow Ups