|
|
|
|
|
|
Subject |
SELLING: RPS Flywheel, Clutch, Pressure Plate, Bearing and Bushing |
|
|
|
|
Posted by |
Boosted1 on November 14, 2009 at 4:37 PM |
|
|
This message has been viewed 434 times. |
|
|
|
|
|
Screen Name: | Boosted1 |
Real Name: | Erik Skaggs |
Phone: | 859 333-zzzz |
Location: | Georgetown, KY 40324 USA |
E-mail: | btskaggs@roadrunner.com |
Research Boosted1's post history
| |
|
|
|
Message |
This is a complete setup with zero miles. This came with a Z I bought a couple of years ago. The previous owner installed it and it would not release, so he took it out and sent it back to RPS. Photo of Invoice is shown below. RPS rebuilt the Pressure plate and Flywheel surfaces, Balanced the entire rotating assembly (Yellow marks in photo below) and sent back. I purchased the car from him before he re-installed. He included with the car and I do not need.Save 25%. All this is 800.00 from vendors. Asking $600.00.
The back of the flywheel. The small drill marks near the 1:00 position are where the Assembly was balanced with the Pressure plate.
Yellow Aligment marks. RPS balanced the entire Rotating Assembly
Here is the Invoice from RPS documenting the Warranty Rebuild
And Finally the Free T-shirt the previous owner requested for the hassle is included
|
|
|
|
|
Follow Ups |
- RPS Flywheel, Clutch, Pressure Plate, Bearing and Bushing - Boosted1
16:37:44 11/14/09
|
|
|
|
|
|
|
|
|
|
|