 |
  |
|
| |
|
|
| Subject |
SELLING: OEM Valve Cover Gasket Kit |
|
| |
|
|
| Posted by |
bryan@Z1 on September 29, 2008 at 3:49 PM |
|
| |
This message has been viewed 664 times. |
|
| |
|
|
| |
| Screen Name: | bryan@Z1 |
| Real Name: | bryan Crawford |
| Phone: | 770-838-7777 |
| Location: | Carrollton, GA 30116 USA |
| E-mail: | bryan@300zx.com |
Research bryan@Z1's post history
| |
| |
|
|
Message |
 Kit with all necessary gaskets needed to reseal your valve covers. The intake valve covers use rubber gaskets and the exhaust valve covers use silicone gasket maker with two rubber plugs in the back. Be sure to clean all of the old sealant off thoroughly before resealing.
Includes:
- 1 Left Valve cover gasket
- 1 Right Valve cover gasket
- 2 rubber half moons seals
- 1 Plenum gasket
- 1 Tube of Ultra Grey Silicone Gasket Maker
If you haven't already done so, when you have the upper plenum removed, we recommend replacing your fuel rail - plenum seals that tend to crack and not seal properly with age. If you have not eliminated your EGR already you may also have to replace the (2) small gaskets that are between the bottom of each side of the upper plenum and EGR tubes. We have all the supplies and gaskets you need in stock here at Z1 Motorsports.
Buy it Now for $48 .JPG)
|
|
| |
|
|
| Follow Ups |
 OEM Valve Cover Gasket Kit - bryan@Z1
15:49:48 09/29/08
|
|
| |
|
|
| |
|
|
| |
|
|
