TwinTurbo.NET: Nissan 300ZX forum - Selling: PE 1420 Turbos and Built Engine
People Seeking Info
 
   


     
Subject SELLING: Selling: PE 1420 Turbos and Built Engine
     
Posted by 300zxracing91 on June 16, 2008 at 9:50 AM
  This message has been viewed 325 times.
     
 
Screen Name:Gibby
Real Name:Jon Gibson
Phone:1-520-891-0355
Location:Tucson, Az 85741 USA
E-mail:ttwinzz@aol.com
Research Gibby's post history
 
     
Message I have a set of PE 1420 turbos I am willing to let go. They sale new for $3600+ on there website and the ones I have only have 1,200 miles on them. They have no shaft play and in great condition. I am slowly parting out my car so these need to go. I am asking $2,000 obo for them. I have seen dynos in the high 500rwhp mark with very little lag. I loved these turbos and so will you.

I am also selling my fully built motor that also only has 1,200 miles on it. The motor is complete from oil pan to upper intake plenum. Asking $4,000

Motor Specs:
88mm Weisco Pistons
Eagle Rods
JWT #500 Cams
JWT HP Valve Springs
JWT Cam Springs
2mm Greddy Head Gasket
ARP Head Studs
ARP Main Studs
Port and Polished Lower Intake
Port and Polished Upper Intake
Port and Polished Exhaust Manifolds
Port and Polished Heads
Multi-Angle Valve Job
Block is Bored .40 over
All new gaskets, rings, bearings
1mm Valves
The whole motor is balanced
***only thing I did not replace on this motor were the lifters because I ran out of money and they looked good still. It cost me $2000 just for the labor on the build. Spent well over $6000 on this motor

     
Follow Ups
  • Selling: PE 1420 Turbos and Built Engine - 300zxracing91 09:50:51 06/16/08