TwinTurbo.NET: Nissan 300ZX forum - Skyline turbo kit fits a Z32, $900!!. 0-60 4.4 sec.
People Seeking Info
 
   


     
Subject SELLING: Skyline turbo kit fits a Z32, $900!!. 0-60 4.4 sec.
     
Posted by z32ttvert (MWS Motorsports) on July 25, 2006 at 5:47 PM
  This message has been viewed 278 times.
     
 
Screen Name:slkttop (MWS Motorsports)
Real Name:Michael Smith
Phone:(408) 555-5555
Location:San Martin, CA 95046 USA
E-mail:mwsmotorsports at gmail dot com
Research slkttop (MWS Motorsports)'s post history
 
     
Message Price is reduced to $900 + ship!! Or best offer.

Everyone talks about it. I did it. Now you can too. But without all the expensive mods to make these work:

Now I'm moving on to the next upgrade stage, and you can have fun with a great set of custom turbos. Sport Compact car magazine raves about the FF3 Tokyo Drift cars doing 0-60 times in excess of 5.8 seconds? How LAME!!!!

Check out the video where I test-drive this turbo kit with the ported manifolds for a 0-60 time of 4.4 seconds.

click here for video



A complete set of Skyline R32 turbos that have been carefully machined, welded, and mated to fit a Z32. They came off my motor and can bolt right up to yours. I made more than 400 RWHP with them. They do not smoke and run fantastically.

0-60 in 4.4 seconds using an NA rear end, 555s and alcohol injection with 18 psi.

All this is documented in the upcoming MWS TV video "School of Swap".

The Skylines require:
The exhaust manifolds to be machined.
The inlet for the turbine to be ported for Z32.
The induction tubes to be cut and re-welded.
The compressor outlets to be welded on.
Special DPs to be made as well as special gaskets.
Special clocking.
Shields to be cut to fit.
Special actuators arms to be cut and brackets to be made.

on and on, there's tons of mods to make them fit and these are already done.

They also come with:
Special 18" long divorced and tapered downpipes. You must use these special 5-bolt DPs, since the Skylines fit nothing else. I did all the work for you.
Special catback system (you use your stock mufflers or any aftermarket muffs, like Stillen or Greddy). This catback system is required for use on this kit.
Special angled compressor outlet steel tubes (J tubes) which fit the stock Z location for the IC hoses (not shown in picture, but they are included)
Special Z32 exhaust manifolds, machined to fit, and with some inner porting for a good 40-50 more hp.

These turbos will not support the EGR system. There is no EGR bung and they are not legal for street use in California.

All this for $900 + ship.

(408) 749-1470

     
Follow Ups