|
You are not currently logged in
Z32 FAQ:
How do I rewire my fog lights??
The way I have my switch wired just results in the fogs and lows staying
on when you turn on the high beams as long as the fog light switch is on.
So then you have the following setup:
SWITCH POSITION FOGS LOWS HIGHS
Off Off Off Off
Parking N/A N/A N/A
Lows On(Fogs Off) Off On Off
Highs On(Fogs Off) Off Off On
Lows on(Fogs On) On On Off
Highs On(Fogs On) On On On
People won't be confused when flipping from high to low, because it's obvious
lights are turning off. With the stock setup, when flipping from high to
low ONE set of lights turns off and TWO come on. With my setup, high to
low results in THREE sets of lights becoming TWO sets, which is much less
confusing to other drivers.
On the bottom of the panel that has the headlight switches and fog light
switch, etc. there's two phillips screws. Remove them and the light control
'pod' is easily removed exposing the wiring behind.
Figure out which wires are coming from the fog light switch. I think
one is green with a yellow stripe. Use a short length of similar gauge
wire to connect this to the nearest black (ground) wire. Don't CUT these
wires, just expose some of the copper inside and splice into them. Or go
to Radio Shack and buy plastic wire splicing pieces (the crimp together
style).
JaimeZX
Back to FAQ Index
|
